Browse by Category
- Special Offers
- New Products
- Chassis & Crash Structures
- Corrosion Inhibitors & Lubricant
- Exterior & Bodywork
- Electrically Operated Parts
- Windscreen Wipers & Washers
- Interior Trim
- Brake System & Ancillaries
- Cylinder Head & Ancillaries
- Engine & Components
- Engine Management & Sensors
- Security & Alarm System
- Gearbox & Drivetrain
- Induction Intake System
- Exhaust System
- Ignition System
- Fuel System
- Heating & Ventilation
- Track + Performance
- Steering + Suspension
- Wheels and Tyres
- Service and Maintenance
- Left Hand Drive Parts
- Genuine Lotus Parts
K Series AP Clutch & Flywheel Package
Kit Includes AP Clutch, Lightweight Flywheel and OEM Flywheel Bolts.
The AP system we stock is the ultimate street clutch available.
It will take 250 BHP+ and over 180lbs per foot of torque which is more than adequate for any normally aspirated K Series engine.
There is no clutch snatch and it's as driveable as any standard clutch system.
Supplied complete as Full 3 piece kit and 6 x OEM Flywheel bolts included.
AP Pressure plate, AP Driven Plate and Upgraded Steel Release Bearing.
Our Flywheel is the Lightest EN24 ALL steel flywheel available, similarly priced others are over 25% heavier.
Special ring cut gear teeth to enhance the strength and enable further machining of the outside lightening holes
Ours has several advantages over any other flywheel. It has a lowest inertia of mass than any other steel flywheel; constructed from the highest quality EN24T steel (Most others are a softer EN8).
Especially stepped central spigot for absolute accurate centralisation (just one thousandth of an inch oversize can put the flywheel out of balance here).
Its trigger teeth are precisely machined to lower the outer rotational mass/weight. This lighter outer ring reduces the rotating mass by around 25% over other LIGHTWEIGHT flywheels.
We have even machined the outer ring gear into the flywheel to make this the strongest yet lightest flywheel available for the ‘K’ Series engine.
The flywheel is then strategically heat treated for ultimate strength and chemically blacked for corrosion resistance.
A lighter flywheel takes less power to turn, giving you a quicker throttle response and less mass to move means more power to your wheels.
Tick over is not affected.
Standard original equipment flywheel weighs over 7kg; most aftermarket lightweight flywheels weigh over 4.5kg.
Weighs only 3.5kg, the extra 1kg is saved from the important OUTER edge.
Original equipment Flywheel Bolts also included worth £20
This fits the following models:
- S1 K SERIES ELISE
- S2 K SERIES ELISE
- S1 EXIGE & MOTORSPORT
- LOTUS 340R